Table of Contents
Advertisement
19
20
FIGURE 3
STEP 3:
• Insert two 2-1/2" ROUND END CAPS (19) into the ends of the ADJ. FOOT SUPPORT (2) as shown in FIGURE 3.
• Insert one 1-3/4" END CAP (20) into the end of the ADJ. FOOT SUPPORT (2) as shown in FIGURE 3.
• Apply two 2-1/2 X 5-1/2" NON-SKID STRIPS (18) to the ADJ. FOOT SUPPORT (2) as shown in FIGURE 3.
• Attach four 3/4 X 1-1/2" GLIDES (24) to the outside of the ADJ FOOT SUPPORT (2) and four GLIDES to the inside of the
tube on the UPRIGHT (1) as shown in FIGURE 3 using the following steps:
• Thoroughly clean all surfaces where the 3/4 X 1-1/2" GLIDES (24) are to be attached.
• Remove the 3/4 X 1-1/2" GLIDES (24) from the paper backing and firmly apply them to all shown surfaces.
• Pull back on the SPRING PIN (21) and CAREFULLY insert the ADJ. FOOT SUPPORT (2) into the UPRIGHT (1) as shown in FIGURE 3.
18
24
2
6
1
Advertisement
Table of Contents
