The Handset At A Glance - Swisscom ATON CL401 User Manual

The handset at a glance

Ð
17
16
15
15.11.07
Hotline
14
13
12
11
10
9
8
.
Please note:
The handset is not registered to your
ISDN
Aton CL base station; please refer to
page 10.
½ ò V
INT 1
09:45
SMS
1 Display (screen) in idle status
2 Charge status of the batteries
= e V U
=
flashes: batteries almost flat
e V U
3 Display keys (page 11)
4 Recall key
- Consultation call (flash)
- Insert a dialling pause (press and hold)
5 Message key
Access to calls and message lists;
Flashes: new message or new call
6 End call key, On/Off key
1
End call, cancel function, go back one menu
2
level (press briefly), back to idle status
(press and hold), activate/deactivate
handset (press and hold in idle status)
7 Hash key
Keypad lock on/off (press and hold in idle
status);
Toggle between upper/lower case and digits
8 Microphone
9 Star key
Ringer melody on/off (press and hold),
3
With an open connection: switch between
dial pulsing/touch tone dialling
4
(press briefly);
Open special characters table
5
10 Key 1
Dial network mailbox (press and hold)
6
11 Connection socket for headset
12 Talk key
Answer a call, open last number redial list
(press briefly), start dialling (press and hold)
When writing an SMS: send SMS
13 Handsfree key
Switch between earpiece and handsfree
7
mode;
Lights up: handsfree activated
Flashes: incoming call
14 Control key (page 11)
15 Bluetooth activated (page 51)
16 Eco range activated (page 13)
17 Signal strength
Ð i Ñ Ò
|
flashes: no reception
Please note:
The Aton CLx308/CL401
here is just used as an example. Depending on
whether you are using an Aton CL102 or an
Aton CL303 handset, the key arrangement and
the menu will be different. For information
about this, please refer to the user guide for
the relevant handset.
(flat to full)
flashes: batteries charging
(high to low)
ISDN
handset shown
1