How To Connect Recorder - Luxman L-505uX Owner's Manual

How to connect record player
Connect between the output terminal of an analog
record player and the PHONO terminal of this unit
with 2 (R and L) pin-plug cables.
For some types of players, the ground wire from the
phono motor or the tone arm should be connected to
the ground terminal of this unit.
The phono equalizer of this unit uses the MM or MC
cartridge.
If an MC cartridge with low output voltage is used,
set the cartridge selector on the front panel to the MC
position.
The output from a record player equipped with a
phono equalizer or from an independent phono
equalizer shall be connected to the line input
terminals of this unit.

How to connect recorder

1. Connection to monitor terminal (playing)
Connect between the line output terminals (LINE
OUT) of a recorder and the monitor terminals of this
unit with pin-plug cables in consideration of R and L.
Now, setting the monitor switch on the front panel or
the remote control to on provides playback.
2. Connection to REC OUT terminal (recording)
When the sound source from the various input
devices is reproduced, which are connected to the
PHONO or LINE terminals of this unit, setting the
recording switch to on allows users to provide the
REC OUT terminal with the signal.
Connection between the REC OUT terminal of this
unit and the line input terminals (LINE IN) of the
recorder with pin-plug cables is required for recording
on the recorder. After the connection, you can enjoy
listening to the sound from the speaker system and
record the sound at the same time.
These output signals for recording are not affected by
the control functions such as the volume control and
tone control functions.
When you need not toggle an input source to be
recorded (especially when a recorder connected to
the recorder output terminals is recording), do not
operate this switch.
Do not insert shortpin plugs into REC OUT. No sound
is generated.
When a CD recorder, tape recorder, or other devices
are connected, be aware that the playback sound
volume becomes low or no sound is generated if the
device extremely decreases the impedance of the
line input terminals of the recorder or causes short-
circuit on the line input terminals or if the recording
switch is set to on.
How to connect PRE OUT/MAIN IN terminal
Either the pre-amplifier or main-amplifier can be
separately used.
When the pre-amplifier or main-amplifier is separately
used, set the separate switch on the front panel to on.
When only the pre-amplifier is used, connect the
PRE OUT terminal of this unit to the input terminal
of another power-amplifier, and when only the main-
amplifier is used, connect the MAIN IN terminal of
this unit to the output terminal of another power-
amplifier.
When this amplifier is used without separating
between pre-amplifier and main-amplifier, set the
separate switch on the front panel to off, or no sound
is generated.
Do not insert shortpin plugs into PRE OUT. No sound
is generated.
NTEGRATED AMPL FIER L-505uX
13