Setting - Mercedes-Benz B-Class Electric Drive W245 Operator's Manual

To receive a correct display in rear-view mir-
ror :, the compass must be calibrated and
the magnetic field zone set.
Setting the compass
Determine your position using the following
X
zone maps.
North America zone map
South America zone map
Push a round pen into opening =
X
( page 248) for approximately 3 seconds.
Y
The zone currently selected appears in
compass display ; (
To select the zone: push a round pen into
X
opening = ( page 248) until the desired
Y
zone is selected.
If, after a few seconds, the display in com-
pass display ; (
Y
direction, the zone has been selected.
Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
calibrate the compass in the open and not
R
in the vicinity of steel structures or high-
voltage transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear
window defroster.
close all doors and the tailgate.
R
Switch on the ignition.
X
Push a round pen into opening =
X
( page 248) for approximately 6 seconds,
Y
until the C C symbol is shown in compass dis-
play ; ( page 248).
Y
Drive your vehicle in a full circle at approx-
X
imately 3 mph (5 km/h) to 6 mph
(10 km/h).
When the calibration has successfully been
completed, the current direction is shown
in compass display ; (
Floormat on the driver's side
G WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Features
page 248).
Y
page 248) changes
page 248).
Y
Z
249