Setting The Air Vents - Mercedes-Benz SLS AMG 2012 Operator's Manual

Table of Contents

Advertisement

Setting the air vents

110
To switch off: press the g button.
X
The indicator lamp in the g button goes
out.
i
Air-recirculation mode deactivates
automatically:
after approximately five minutes if
R
outside temperatures are less than about
41 ‡ (5 †)
after approximately five minutes if
R
cooling with air dehumidification is
deactivated
after approximately 30 minutes if outside
R
temperatures are over about
41 ‡ (5 †)
Setting the air vents
Important safety notes
G
WARNING
When operating the climate control, the air
that enters the passenger compartment
through the air vents can be very hot or very
cold (depending on the set temperature). This
could cause burns or frostbite to unprotected
skin in the immediate area of the air vents.
Always keep sufficient distance between
unprotected parts of the body and the air
vents. If necessary, use the air distribution
adjustment to direct the air to air vents in the
vehicle interior that are not in the immediate
area of unprotected skin.
In order to ensure the direct flow of fresh air
through the air vents into the vehicle interior,
please observe the following notes:
keep the air inlet on the right-hand side of
R
the hood free of blockages, such as ice,
snow or leaves.
never cover the air vents or air intake grilles
R
in the vehicle interior.
i
For virtually draft-free ventilation, adjust
the sliders of the air vents to the center
position.
Setting the center air vents
To open the center air vent
1
To close the center air vent
2
Center air vent, right
=
Center air vent, left
?
To open the center air vent: turn the
X
adjuster in center air vent = or ? in the
direction of the arrow to position 1.
To close the center air vent: turn the
X
adjuster in center air vent = or ? in the
direction of the arrow to position 2.
Setting the side air vents
To open the side air vent
1
To close the side air vent
2
Side window defroster vent
=
Side air vent
?

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sls 2012

Table of Contents