Mercedes-Benz B-Class Electric Drive W245 Operator's Manual page 249

Table of Contents

Advertisement

Proceed as follows:
if you live in Canada
R
if you have difficulties programming the
R
garage door opener (regardless of where
you live) when using the programming
steps.
Integrated garage door opener in the rear-view mir-
ror
Press and hold button ;, = or ? of the
X
integrated garage door opener.
After a short time, indicator lamp : lights
up yellow.
Release the button.
X
Indicator lamp : flashes yellow.
Press button B of remote control A for
X
2 seconds, then release it for 2 seconds.
Press button B again and hold for
X
2 seconds.
Repeat this sequence on button B of
X
remote control A until indicator lamp :
lights up green.
If indicator lamp : turns red, repeat the
process.
Continue with the other programing steps
X
(see above).
Problems when programming
Integrated garage door opener in the rear-view mir-
ror
If you are experiencing problems programing
the integrated garage door opener on the
rear-view mirror, take note of the following
instructions:
Check the transmitter frequency of garage
R
door drive remote control A. This can usu-
ally be found on the back of the remote
control.
The integrated garage door opener is com-
patible with devices that have units which
operate in the frequency range of 280 to
433 MHz.
Replace the batteries in garage door
R
remote control A. This increases the like-
lihood that garage door remote control A
will transmit a strong and precise signal to
the integrated garage door opener.
When programming, hold remote control
R
A at varying distances and angles from the
button which you are programming. Try var-
ious angles at a distance between 2and
12 inches (5to 30 cm) or at the same angle
but at varying distances.
If another remote control is available for the
R
same garage door drive, repeat the same
programming steps with this remote con-
trol. Before performing these steps, make
sure that new batteries have been installed
in garage door drive remote control A.
Note that some remote controls only trans-
R
mit for a limited amount of time (the indi-
cator lamp on the remote control goes out).
Features
247
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents