Status Messages - Novexx ALX 924 User Manual

ALX 92x
User Manual

STATUS MESSAGES

Error messages
When a fault occurs, the printer shows an error message on the control panel.
Error messages are based on the following outline:
Print status
Rewinder init
a) Depending on the cause of the error, "Print Status" or "Queue Status" appears here. "Print Status" =
message from the printer controller; "Queue Status" = message from the Easy-Plug Interpreter.
b) 5144 = The status number. This number is an easy way to identify the message.
c) "Rewinder init" = Status text; brief description of the error.
To delete an error message:
1. Rectify the cause of the fault. For further details see section
page 66.
2. Press the
Error messages that are not described below can only be rectified by qualified service personnel.
If an error that is not described here occurs:
1. Press the
2. Switch off the device, wait for 30 seconds and switch it on again.
If the error occurs repeatedly:
 Call in a service technician.
Error messages not mentioned here are described in the service manual.
While an error message is being displayed, the "Error" signal output is active.
List of error messages
No gap found
5001
The label sensor has not found a label starting mark (punch or reflex marking).
 Incorrect setting of the material type.
 Check to ensure the setting of
are using.
 Incorrect sensor type set
 Check to ensure the set sensor type matches the label material (punches or reflex markings).
 Incorrect label material inserted (material does not match the setting in
terialtype)
Check the label material.

 Incorrect position of label sensor.
Check/correct position of label sensor.

 Material guide not set correctly - the label starting marks are running past to the side of the label
sensor.
Check/correct the material guide setting.

 Label sensor is dirty.
 Clean the label sensor.
09/2016 | 00
a b
: 5144
c
key to delete the message.
key to delete the message.
PRINT PARAMETERS > Materialtype
(SYSTEM PARAMETER > Label sens.
List of error messages 
matches the label material you
type).
70
on
PRINT PARAMETERS > Ma-
Startup and Operation