Changing Ribbon - Novexx ALX 924 User Manual

ALX 92x
User Manual

Changing ribbon

With roll diameter monitoring
We recommend switching on roll diameter monitoring,
see section Ribbon reserve 
As soon as the critical diameter is reached, the mes-
sage appears:
FOILØ X JOBS
Follow these steps:
1. Open the front cover.
The printer prints the current label completely and
then stops.
PrintStatus:
Cover open
2. Change the ribbon roll.
3. Close the front cover.
The status message is confirmed automatically.
4. Press the FEED key.
The current print job continues.
Without roll diameter monitoring
As soon as the ribbon roll is used up, the following mes-
sage appears:
PrintStatus: 5008
Foil end
The printer stops immediately, without printing the cur-
rent label.
1. Open the front cover.
Print status:
Cover open
2. Change the ribbon roll.
3. Close the front cover.
The status message is confirmed automatically.
4. Press the ONLINE key to confirm the ribbon end
message.
5. Press the FEED key.
6. Remove the label that was not completely printed.
The last (incomplete) label to be printed will be
printed again. Then printing continues with the cur-
rent print job.
09/2016 | 00
on page 66.
5103
5103
60 Startup and Operation