Disk Setup; Build Raid Volume - Seenergy svr-632u nvr User Manual

100 SVR-632U/S User Manual

Disk Setup

Once you install a hard disk to the recorder, you would need to
initialize it so that it can be ready for recording. You can obtain basic
information about the disk you installed in this page.
To initialize it, simply click the "Format" button.
*This page will list the Internal disks (or RAID volumes), and the E-
SATA disk. The HDD will be formatted in EXT4 file system.
*Due to the chipset limitation, "Hotswap" is NOT supported for E-SATA
HDD & internal HDD. Please make sure to power on the E-SATA
external HDD and plug it in to the NVR before the NVR is turned on.
*The USB HDDs will only be listed in the "USB Backup" and "Hard Disk
Status pages in "System Options". The USB HDDs have to be
formatted in advance in FAT32 file system.
* Please plug in the USB HDD only after the NVR is fully started. The
internal HDDs will NOT be properly detected if the NVR is powered on
with USB HDD plugged in

Build RAID Volume