Seenergy svr-632u nvr User Manual page 163

SVR-632U/S User Manual 163
To enable network UPS support (NVR acting as UPS
slave):
1. Go to "NVR Setup" >> "System Options" >> "UPS Configurations",
and check "Enable UPS Support" option.
2. Enter the IP address of the NVR running as UPS server. (The
NVR with USB UPS physically attached to)
* Please make sure both NVRs (UPS server and slave) are on the same
local network to ensure the communication between the two.
* Please make sure both NVRs are plugged into the outlets that
connect to the UPS.