Network - Seenergy svr-632u nvr User Manual

SVR-632U/S User Manual 187

Network

You need to adjust settings in this page for the device to work properly
in your network. It is critical that settings here are configured correctly
based on your network configurations so that the recorder can be
administered through the local area network and cameras can be
connected from it.
By default, the recorder is set to "Auto Mode" which if there's a DHCP
server in the same local network, the NVR can obtain IP address from
the DHCP server. And you can locate the NVR by using the NVR search
utility.
If there's no DHCP server in the network, and the NVR is set to use
"Auto Mode", it will use its own default static IP 192.168.101.50.
* The recorder can detect the presence of a DHCP server upon startup.
It sets itself to use static IP address if there is no DHCP server
currently presented in the network. Its DHCP server function is also
turned on at the same time to assign IP addresses to cameras that are
later connected to the network or you can manually turn off the DHCP
server function at the bottom of this page.