Seenergy svr-632u nvr User Manual page 162

162 SVR-632U/S User Manual
To enable local UPS support (NVR acting as UPS
server):
1. Connect the compatible USB UPS to the NVR
2. Turn on the NVR
3. Go to "NVR Setup" >> "System Options" >> "UPS Configurations",
and check "Enable UPS Support" option.
You can adjust how long the UPS stays on to provide backup electricity
to the NVR after a power failure by choosing one of the options from
the drop-down shown below:
* Currently only APC Smart-UPS 750 is supported (05282012)
The UPS information should be obtained and displayed at the bottom
of the page after the settings are applied: