Drill Guard
Locate the drill guard assembly (5), loosen the Phillips screw
and nut to the rear of the guard, see fig 29 insert the assembly
up over the lower bearing flange of the quill until the assembly
is up against the drill casting, re-tighten the screw and nut to
lock the guard assembly in place, see fig 30.
Fig 29-30
Lever Feed Handles
Locate the three lever feed handles (6) and screw them into the
threaded holes on the depth stop ring, see fig 31-32.
Fig 31-32
5
6
A
C
D
13
Assembly
6
B
E
Model
Letter
AHDP13B
A
AHDP16B
B
AHDP16F
C
AHRD16B
D
AHRD16F
E