Axminster AHDP13B User Manual page 12

Assembly
NOTE: Make sure the spacer block does not come out when
lifting the drill head onto the column!
Fig 21
10
3. Locate another lift and shift handle (10) and screw it into the
threaded hole for the Horizontal clamp assembly, see fig 22.
Fig 22
10
4. Open the pulley cover and check to see if the belt has been
tensioned. If not, loosen the two motor yoke locks and push the
motor back to tension the belt, see fig 23-24-25. For the floor
standing pillar drill head, move the tensioning lever back then
re-tighten the motor yoke locks to lock the motor in place, see
fig 24-25.
Fig 25-26
Motor yoke clamp
Tensioning lever
1-13mm Keyless Chuck AHDP13B Only
Locate the chuck (7) and insert it up over the morse taper arbor,
using a high faced mallet, lightly tap it home.
3-16mm Keyless Chuck
Locate the morse taper arbor (8), insert the arbor into the
keyless chuck (7) then slot the assembly up into the quill.
Using a high faced mallet, lightly tap it home., see fig 27-28.
7
12
Fig 25-26
Motor yoke clamp
Fig 27-28
8