[ Connection of the pedal of standing-work machine ]
How to fix cable clip band
Panel
Pull
B
9) Connect connector 4P to connector located
on the side of the box.
10) Connect motor output cord of the power switch to
connector .
❷
Connect the connector of PK70 to connector
(CN39 : 12P) of SC-920.
(Caution) Be sure to turn OFF the power before
connecting the connector.
7) After inserting the connector, put all cords together
with cable clip band located on the side of the
box.
(Caution) 1. Fix the cord clamp and the cable clip
band following the attaching proce-
dure.
2. When removing the connector, re-
move it from the wire saddle and
remove it while pressing the hook of
the cable clip band.
How to remove cable clip band
Panel
Push the
hook.
Push
8) Close cover ❷ and fix the cover by tightening screw
B with a screwdriver.
(Caution) Take care not to allow the cord to be
caught under cover ❷ .
11) Bundle the machine head cables with a cable clip
supplied with the operation panel at one location
as shown in the figure.
– 7 –
P u s h i n g t h e
hook portion,
push the band
to remove it.