JUKI SC-920 Instruction Manual page 33

Output function list
Function Abbrevi-
code ation
0 noP No function
1 TrM Thread trimming output
2 WiP Thread wiper output
3 TL Thread release output
4 FL Presser lifter output
5 bT Reverse feed stitching output
6 EbT EBT cancel monitor output
7 SEbT Reverse feed stitching at start/
end cancel monitor output
8 AUbT Sewing start/end cancellation/
addition monitor output
Sewing machine stop state
9 SSTA
output
10 CooL Needle cooler output
11 bUZ Buzzer output
12 LSWo Revolution command output
13 TSWo Tsw command monitor output
Input function setting connectors
Connector No. Pin No.
CN36 4
CN48 2
CN50 12
CN36 5
CN50 11
7
11
CN39
9
5
CN57 1
CN42 2
CN54 3
Output function setting connector
Connector No. Pin No.
7
CN50 8
9
Function item
Display No.
i01
i02
i03
i04
i05
i06
i07
i08
i09
i10
i11
i12
Display No.
o01
o02
o03
– 31 –
Remarks
(Standard setting)
Output of thread trimming signal
Output of thread wiper signal
Output of thread release signal
Output of presser lifting signal
Output of reverse feed stitching signal
State of one time cancel of reverse feed stitching at
end function is output.
State of cancel of reverse feed stitching at start/end is
output.
State of cancel or addition of automatic reverse feed
stitching is output.
Sewing machine stop state is output.
Output for needle cooler
It is output when the bobbin counter set value has been
exceeded, an error has occurred or the bobbin thread
remaining amount is detected.
Revolution demanding command state is output.
Thread trimming command status is output.
Initial value of function setting
noP (No function setting)
SFSW (Safety switch input)
SoFT (Soft-start speed limit input)
bT (Reverse feed stitching switch input)
LinH (Input of prohibition of depress on front part of
pedal)
TSW (Thread trimming switch input)
LSSW (Low-speed revolution switch input)
HSSW (High-speed revolution switch input)
FL (Presser foot lifting switch input)
CUnT (Sewing counter input)
noP (No function setting)
noP (No function setting)
Initial value of function setting
bT (Reverse feed stitching output)
TrM (Thread trimming output)
LSWo (Revolution request input)