JUKI SC-920 Instruction Manual page 23

Hide thumbs Also See for SC-920:
Table of Contents

Advertisement

Sewing can be performed with the production support data displayed on the control panel.
[Basic operation of the production support modes]
3) Data attached marked with (*1) in Table 1 "Indicator
switch ❻ .
switch ❻ held pressed for two seconds, indicator
4) When you keep
they are flashing on and off, data marked with (*2) in Table 1 "Display under modes" can be changed by press-
switch ❺ and
ing
When you press
flashing on and off.
5) The value with a sharp mark (*3) in Table 1 "Display of modes" can be changed only immediately after resetting
switch ❺ and
by using
6) Refer to the table "Mode resetting operation," for the resetting procedure of data.
7) To return to the normal sewing state, press
Data to be displayed under the respective modes are as described in the table below.
Table 1: Display of modes
Mode name
Target No. of pcs. display
mode (F100)
Target/actual No. of pcs.
difference display mode
(F200)
Sewing machine availabili-
ty rate display mode (F300)
Pitch time display mode
(F400)
Average number of revolu-
tions display mode (F500)
Bobbin counter display
mode
switch ❻ .
switch ❼ , the value marked with (*2) is confirmed and indicator
switch ❻ .
Indicator Ⓐ
Actual number of pieces
(Unit : piece) (*1)
Difference between target
number of pieces and
actual number of pieces
(d : piece) (*1)
oP-r
Pi-T
ASPd
bbn
1) When
the normal sewing state, LED Ⓔ lights
up to enter the production support
mode.
2) Production support function can be
changed over by pressing
❸ or
" can be changed by means of
and LED
switch ❼ .
Indicator Ⓑ
Target number of pieces
(Unit : piece) (*2)
Target pitch time
(Unit : 100 msec) (*2)
Sewing machine availabili-
ty rate in the previous sew-
ing (Unit : %)
Pitch time in the previous
sewing (Unit : 1sec)
Average number of rev-
olutions in the previous
sewing (Unit : sti/min)
Bobbin counter value (*3)
– 21 –
switch ❼ is pressed in
switch
switch ❹ .
switch ❺ and
flash on and off. While
and LED
stop
Indicator Ⓑ (when
switch
is pressed)
-
-
Display of average
availability rate of sewing
machine (Unit : %)
Display of average pitch
time (Unit : 100 msec)
Display of average num-
ber of revolutions
(Unit : sti/min)
-

Advertisement

Table of Contents
loading

Table of Contents