Digital I/O Connections; Computer Connections - Agilent Technologies 66319B User Manual

3 - Installation

Digital I/O Connections

As shown in Table 3-3 and Figure 3-10, the 4-pin connector can also be configured as a digital I/O
port. Information on programming the digital I/O port is found in chapter 5 and under
[SOURce:]DIGital:DATA and [SOURce:]DIGital:FUNCtion commands in chapter 8. The electrical
characteristics of the digital connector are described in appendix A.

Computer Connections

The dc source can be controlled through a GPIB interface. Follow the GPIB card manufacturer's
directions for card installation and software driver setup.
GPIB Interface
Each dc source has its own GPIB bus address, which can be set using the front panel
described in chapter 5. GPIB address data is stored in non-volatile memory. The dc source is shipped with
its GPIB address set to 5.
Dc sources may be connected to the GPIB interface in series configuration, star configuration, or a
combination of the two, provided the following rules are observed:
♦
The total number of devices including the GPIB interface card is no more than 15.
♦
The total length of all cables used is no more than 2 meters times the number of devices connected
together, up to a maximum of 20 meters. (Refer to table 2-2 for a list of available GPIB cables.)
♦
Do not stack more than three connector blocks together on any GPIB connector.
♦
Make sure all connectors are fully seated and the lock screws are firmly finger-tightened.
38
Figure 3-10. Digital I/O Examples
key as
Address