Agilent Technologies 66319B User Manual page 114

8 – Language Dictionary
Command Syntax [SOURce:]DIGital:DATA[:VALue] <NRf>
Parameters 0 to 7
*RST Value 0
Examples DIG:DATA 7
Query Syntax [SOURce:]DIGital:DATA?
Returned Parameters <NR1>
[SOURce:]DIGital:FUNCtion
Configures the 4-pin control port. The configuration setting is saved in non-volatile memory.
Configures the port for Remote Inhibit/Discrete Fault Interrupt operation
RIDFi
Configures the port for Digital input/output operation (see DIG:DATA)
DIGio
TRIGger Configures the port to accept external measurement triggers
(only applies to units with firmware revision A.03.01 and up)
Command Syntax [SOURce:]DIGital:FUNCtion <CRD>
Parameters RIDFi | DIGio | TRIGger
Examples DIG:FUNC DIG
Query Syntax [SOURce:]DIGital:FUNC?
Returned Parameters <CRD>
CAUTION: This command causes a write cycle to nonvolatile memory. Nonvolatile memory has a
finite maximum number of write cycles. Programs that repeatedly cause write cycles to
nonvolatile memory can eventually exceed the maximum number of write cycles and
cause the memory to fail.
[SOURce:]RESistance
This command sets the output resistance of the dc source.
Command Syntax [SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude]<NRf+>
Parameters see Table 8-3
*RST Value 0
Examples RES 0.5
Query Syntax [SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude]?
Returned Parameters <NR3>
Related Commands RES:TRIG
[SOURce:]RESistance:TRIGger
This command sets the pending triggered output resistance of the dc source.
Command Syntax [SOURce:]RESistance[:LEVel]:TRIGgered[:AMPLitude] <NRf+>
Parameters see Table 8-3
*RST Value 0
Examples RES:TRIG 1
Query Syntax [SOURce:]RESistance[:LEVel]:TRIGgered[:AMPLitude]?
Returned Parameters <NR3>
Related Commands RES
114
!set output resistance to 0.5Ω
!set triggerd resistance to 1Ω