Common Commands - Agilent Technologies 66319B User Manual

8 – Language Dictionary
TRIGger:SEQuence1:DEFine
TRIGger:SEQuence2:DEFine
These commands define the names that are aliased to trigger sequences 1 and 2. The command accepts
only ACQuire for sequence 2 and TRANsient for sequence 1 as predefined names. The query allows the
user to query the instrument names aliased to sequences 1 and 2.
Command Syntax TRIGger:SEQuence1:DEFine TRANsient
Parameters TRANsient, ACQuire
Examples SEQ1:DEF ACQ
Query Syntax TRIGger:SEQuence1:DEFine?
Returned Parameters <CRD>
Related Commands TRIG:SEQ2:ACQ

Common Commands

*CLS
This command causes the following actions (see chapter 7 for the descriptions of all registers):
$ Clears the Standard Event Status, Operation Status Event, and Questionable Status Event registers
$ Clears the Status Byte and the Error Queue
$ If *CLS immediately follows a program message terminator (<NL>), then the output queue and the
MAV bit are also cleared.
Command Syntax *CLS
Parameters None
*ESE
This command programs the Standard Event Status Enable register bits. The programming determines
which events of the Standard Event Status Event register (see *ESR?) are allowed to set the ESB (Event
Summary Bit) of the Status Byte register. A "1" in the bit position enables the corresponding event. All
of the enabled events of the Standard Event Status Event Register are logically ORed to cause the Event
Summary Bit (ESB) of the Status Byte Register to be set. The query reads the Standard Event The query
reads the Standard Event Status Enable register.
Table 8-6. Bit Configuration of Standard Event Status Enable Register
Bit Position 7
Bit Name PON
Bit Weight 128
PON = Power-on has occurred
CME = Command error
EXE = Execution error
130
TRIGger:SEQuence2:DEFine ACQuire
TRIGger:SEQuence2:DEFine?
6 5 4
0 CME EXE
64 32 16
DDE = Device-dependent error
QUE = Query error
OPC = Operation complete
SEQ2:DEF TRAN
TRIG:SEQ1:TRAN
3 2
DDE QUE
8 4
1 0
0 OPC
2 1