Connecting To An Antenna - Pioneer PDP-506XDE Operating Instructions Manual

Preparation

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used
for a coaxial cable.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
Antenna cable (commercially available)
I N O U T
SERVICE ONLY
CONTROL
INPUT 1
ANT i /o link.A
SELECT
INPUT
2 3
INPUT 1
I N O U T
SERVICE ONLY
CONTROL
INPUT 1
ANT i /o link.A
SELECT
INPUT
2 3
INPUT 1
• For viewing analogue broadcasts only, connect
If your outdoor antenna uses a 75-ohm coaxial cable with a standard
DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of
the Media Receiver.
• For viewing both analogue and
digital broadcasts, connect the
antenna cable to the ANT OUT
terminal (antenna through out)
and ANT (analogue input)
terminal.
• If "Aerial Power" setting is
enabled, use an indoor antenna
with signal amplifier, 5V 30mA.
IN
OUT IN OPTICAL
DIGITAL OUT COMMON INTERFACE
ANT(DIGITAL)
INPUT 2
Y P P R-AUDIO-L SUB
B R
WOOFER
COMPONENT VIDEO AUDIO OUTPUT
INPUT 3
HDMI HDMI BLACK WHITE
INPUT 4 SYSTEM CABLE
OUT
OUT IN OPTICAL
DIGITAL OUT COMMON INTERFACE
ANT(DIGITAL)
INPUT 2
R-AUDIO-L SUB
Y P B P R
COMPONENT VIDEO WOOFER
AUDIO OUTPUT
INPUT 3
HDMI HDMI BLACK WHITE
INPUT 4
SYSTEM CABLE
the 75-ohm coaxial cable (commercially
available) to ANT (analogue input) terminal.
05
AC IN
AC IN
21
En