Basic Connections; Connecting To An Antenna; Connecting The Power Cord - Pioneer PDP-436FDE Operating Instructions Manual

Preparation
05

Basic connections

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used
for a coaxial cable.
Antenna cable (commercially available)

Connecting the power cord

Plasma Display (rear view)
SYSTEM
CABLE
WHITE
BLACK
SYSTEM
CABLE
WHITE
BLACK
Media Receiver (rear view)
SERVICE ONLY
INPUT 2
INPUT 1
ANT I /o link.A R -AUDIO -L
Y P B P R
SELECT
COMPONENT VIDEO AUDIO OUTPUT
INPUT
2 3
INPUT 2 INPUT 3
HDMI
NOTE
• Disconnect the power cord from the power outlet, Plasma Display and Media Receiver when the system is not going to be used
for a long period of time.
20
En
If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325 plug
(IEC169-2), plug it into the antenna terminal at the rear of the Media Receiver.
AC IN
BLACK WHITE
SYSTEM CABLE
SERVICE ONLY
INPUT 2
INPUT 1
ANT I /o link.A R -AUDIO -L
Y P B P R
SELECT
COMPONENT VIDEO AUDIO OUTPUT
INPUT
2 3
INPUT 2 INPUT 3
HDMI
• Connect the 75-ohm coaxial cable (commercially available) to the
ANT (antenna input) terminal.
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core
to the connector end of the power cord as shown. Use
the supplied cable tie to prevent the ferrite core from
slipping on the cable.
Europe, except UK
and Eire
To power
outlet
UK and Eire
Europe, except UK
and Eire
UK and Eire
AC IN
BLACK WHITE
SYSTEM CABLE
AC power cord
As close as possible
Ferrite core
Cable tie
To AC IN