Remote-A Or B Selection; Hi-Power Mode - Carrier 42cvur018-703 Service Manual

Item
Setting the remote controller
12. Romote-A or B
selection
To separate using of remote control for each indoor unit
in case of 2 air conditioners are installed nearly.
Remote Control B Setup.
1. Press [
air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold [
by the tip of the pencil. "00" will be shown on
the display (Picture
4. Press [
will show on the display and "00" will disappear
and the air conditioner will turn OFF. The Remote
Control B is memorized [Picture
NOTE : 1. Repeat above step to reset Remote
13. Hi-POWER
([Hi-POWER] button on the remote controller
operation
is pressed)
When [Hi-POWER] button is pressed while the indoor
unit is in Auto, Cooling or Heating operation, Hi-
POWER mark is indicated on the display of the remote
controller and the unit operates as follows.
1. Automatic operation
• The indoor unit operates in according to the
2. Cooling operation
• The preset temperature drops 1ºC
3. The Hi-POWER mode can not be set in Dry
Operation flow and applicable data, etc.
] button on the indoor unit to turn the
] button on the Remote Control
1 ).
] during pushing [
Control to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
1
current operation.
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increase 1 tap
operation
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or
nearby rooms, this operation prevents the
remote controller signal from being
received simultaneously by both units,
thus preventing both units from operating.
]. "B"
3. Operation
The indoor unit on which the remote
controller selection has been set to B
2
).
receives the signal of the remote control-
ler also set to B.
(At the factory the remote controller
selection is set to A on all the indoor
units. There is no A setting display.)
2
− 33 −
FILE NO. SVM-12052
Description