Initial Setup - Philips 55PFL5907 User Manual

Initial setup
This section will guide you through the unit's initial setting which
includes selecting a language for your on-screen menu, country, location
and AutoProgram, which automatically scans and memorizes viewable
channels.You can also set the network connection in this setting,
Before you begin:
Make sure the unit is connected to antenna or cable.
t After making all the necessary connections, press _ to Turn On the
unit.
* It may take a few moments to Turn On the unit for the first time,
* Initial setup menu appears automatically after the unit isTurned
On,
2 Use & Y to select the on-screen language, country, location on the
right side oftheTV screen, then press OK.
* You must set Home in location setting, Otherwise, Picture and
Sound settings you adjusted will not be memorized after the unit
goes into Standby mode,
3
Use & Y to select the signal type.
. IftheTV is connected to a cable box or satellite set-top box,
select the 2nd one and skip to step 5.
5 After the channel installation is completed, Network setup screen
will appear, Use & Y to select Wireless or Wired,then press OK,
6
4
Use & V to select Antenna forTV channelsor Cable for CATV
channels, t hen press OK.
7
If you have a Wireless router, select Wireless to
Wireless connect to the Inter'net
If you connect with an Ether'net cable, select
Wired Wired to connect to the Inter'net.
• If you have a router with WPS function, select Wireless and use
& Y to select Easy Connect, then press OK,
Follow the on-screen instructions to complete the installation.
• When you select On in the selection screen of
Auto software update.A message will appear if there is the
latest software on the network server,
Use _ 1_ to select Start, then press OK to begin Settings assistant.
8 Press _ or _ 5 times to selectthe side ofthe pictures that isthe
most pleasing to you, then press OK,
- When Antenna is selected, theTV detects antenna signals. It searches
for DTV and AnalogTV channels available in your area.
- When Cable is selected, theTV detects signals supplied by cable. It
searches for DT_, AnalogTV and Cable channels available in your
area.
• Autoprogram will begin.
Continued on next page.