Switching On And Initial Setup - Philips 32PFL1507 User Manual

Switching on and initial setup
Before you switch on the TV, check that the AC power cord is properly
connected. Press . (POWER / STANDBY-ON) on the front panel of
the TV, or press . (POWER / STANDBY-ON) on the remote control.
The TV normally takes 25-30 seconds to start up and the following
screen appears the first time you turn on the TV.
Initial Setup
Initial Setup
Select your menu language.
Seleccione el idioma para el menú.
Sélectionnez la langue du menu.
Select OK
OK
Follow the on-screen instructions to select your language and complete
your TV setup. Installation takes approximately 10 minutes.
Press Í or Æ to select the desired mode for energy saving, then press
OK.
Select "Retail" or "Home" for your location.
Retail
Select
Select [Retail] if you want backlight to be brighter.
Select [Home] to reduce power consumption.
You must set [Home]. Otherwise, personalized picture and sound
settings will not be memorized after the unit goes to standby mode.
Select [Retail], the unit will be set up with predefined setting for
•
retail displays.
• Select [Home], the unit will be set to maximize energy efficiency.
Picture and sound settings can be adjusted and saved as per your
personal preferences.
Press OK to begin [Settings assistant].
Settings assistant helps you customize picture settings. You will
see a series of test pictures where the right side and left side
differ. Select the side that is most pleasing to you with the Left/
Right keys.
Next
OK
English
Español
Français
MENU
Skip
Home
OK
BACK MENU
Back Exit
Press Í or Æ 5 times to select the side of the pictures that is the most
pleasing to you. then press OK.
Left side
1/5 Select the picture setting that you prefer.
Select Next
OK
Press OK to finish [Settings assistant].
You have set up your viewing preferences.
Store
OK
Finish the Setup.
Note
•
If you are not receiving a signal from your cable service, contact the CATV provider.
•
If you press . or MENU during autoprogram, this setting will be canceled.
•
The initial autoprogram function can be executed for either [Antenna] or [Cable]
only once. When you change the connection (Antenna / Cable), set autoprogram again.
(Refer to page 24.)
•
If there is no signal input from the antenna terminal and no operation for several
seconds after you turn on the TV, [Helpful Hints] appears. Follow the instructions
listed on the TV screen.
Right side
BACK MENU
Back Exit
BACK MENU
Back Exit
11
English