Channel Installation - Philips 55PFL5907 User Manual

Channel installation
Be sure the RF cable is correctly connected to this unit and you are
registered with your cableTV provider when you install cable channels.
Autoprogram
If you switch wires (e.g. between antenna and CATV) or if you move
the unit to a different area after the initial setting, or if you restore the
DTV channels you deleted, it is recommended to use AutoProgram to
perform a new channel search.
You need to select the signal type in Installation mode before you
perform AutoProgram.
t Use A Y to select Channels,then press OK,
_- Use A T to select Autoprogram,then press OK,
• If you run Autoprogram when you have Locked channels, a
message appears asking to enter your PIN code. Enter your
PIN code in order to complete the installation.You need to set
the channel loci( again after the installation.
3 Press OK to select Start now.
• When the scanning and memorizing are completed, the lowest
memorized channel will be displayed.
4 Follow the on-screen instructions to complete the installation.
• After setting Autoprogram, using CH +/- skips unavailable programs automa±ically,
• If you are not receiving a signal from your cable service, contact the cable provider:
• If you press (!) or during AutoPrograrn, the setup of TV channels will be canceled.
• Even if Autoprogram is completed, the char_nel setting will be lost if the AC power-
cord is unplugged before the unit goes into Standby mode by pressing (I).
• The PIN code will be required once you set a PIN code in the Child and ratings loci<.
,_ p.34
• If you want to change your- PIN code, follow the instruction of Change PIN. ,ll_ p.36
VVeak channel installation
This function lets you add the channels that were not added by the
AutoProgram due to the reception conditions during the initial setup.
It is available only when you select Antenna in Installation mode.
t Use A T to select Channels,then press OK.
_- Use A T to select Weak channel installation, then press OK.
• The PIN code will be required if you have locked channels.
3 Use _l I_ to select channel Input box, then use A T to select a
channel you want to memorize.
4 Use _l 1_ to select Search, then press OK.
5 Display will be changed to Store from Search when the channel is
found,then press OK.
• In most cases, Digital channels are not broadcast on the RF channel on which they
appear on yourT_To add Digital channels you need to know the RF channel on which
the Digital channel is being broadcast, (e.g, If there is a Digital channel 9,1 which is being
broadcast on RF channel 25, you need to enter 25 while performing a weak channel
instalbtion.) To find out the RF channel on which a particular Digital channel is being
broadcast please contact your local service providel:
Installing Digital channels using Weak channel installation might not work for direct
cable connections and if the Digital signal is too weak for the TV to process.
Installation mode
t
2
3
Use A T to select Channels,then press OK.
Use A T to select Installation mode, then press OK.
Use A T to select Antenna or Cable, then press OK.
• When Antenna is selected, theTV detects antenna signals. It
searches for DTV and AnalogTV channels available in your area.
• When Cable is selected, theTV detects signals supplied by cable.
It searches for DTV AnalogTV and Cable channels available in
your area.
Uninstall channels
The channels selected here can be skipped when selecting the channels
using CH +/-.
Those channels can still be selected with the NUMBER buttons,
t Use A Y to select Channels,then press OK.
2
Use A T to select Uninstall channels,then press OK.
3 Use A T to select the channel you want to remove, then press O K.
• The removed channels are not displayed on the list of favorite
channels,
• To reactivate a removed channel, use A T then press OK,