Switching On And Initial Setup - Philips 55PFL3907/F8 User Manual

Switching on and initial setup

Before you switch on the TV, check that the AC power cord is properly
connected. Press . POWER at the right side of the TV, or press
. (standby-On) on the remote control. The TV normally takes 25-30
seconds to start up and the following screen appears the fi rst time you
turn on the TV.
After you read a welcome screen, follow the on-screen instructions
to select your language and complete your TV setup. Installation takes
approximately 20 minutes.
Select your menu
language with the
Up/Down buttons on
your remote control,
press the OK button to
proceed.
Network setup screen will appear. Use Î /ï/Í /Æ to select [Next] >
[Wireless] / [Wired], then press OK.
If you select [Wireless], use Î /ï to select a setting and then press
•
OK.
Setting items Description
Select this setting if your router has a Wi-Fi
Protected Setup (WPS) button. Start scanning
for wireless networks on the TV after pressing
Easy connect
the WPS button on your router. If connection
test fails, refer to the router's manual for more
details.
Search for wireless networks automatically
and select the wireless network name (SSID)
Scan
from the list. see 'Wireless network setting
(Auto)'on page 29.
If you select [Wired], use Î /ï to select a setting and then press
•
OK.
Connection test will start automatically. (See 'Connection test' on page 29.)
Press Î /ï to select the desired mode for energy saving, then press OK.
"Home" is recommended for
normal home use.In the Retail
Store mode all settings are
fixed.
Select [Retail store] if you want backlight to be brighter.
Select [Home] to reduce power consumption.
E Eng E English ng ng g g g lish li li sh sh
Français
Español
Retail store
Home
You must set [Home]. Otherwise, personalized picture and sound
settings will not be memorized after the unit goes to standby mode.
Select [Retail store], the unit will be set up with predefi ned setting
•
for retail displays.
Select [Home], the unit will be set to maximize energy effi ciency.
•
Picture and sound settings can be adjusted and saved as per your
personal preferences.
Press Í /Æ to select [ Start], then press OK to begin [ Settings assistant].
Settings assistant will allow you to customize your picture settings to
your personal preference. You will see a series of test pictures where
the right side and left side differ. Select the side that is most pleasing to
you with the Left/Right buttons.
Cancel
Select [ Picture A] or [ Picture B] by pressing Í /Æ that is the most
pleasing to you, then press OK. You see 5 different pictures to be
completed.
Which side of the picture do you prefer?
Cancel Picture A
Press Í /Æ to select [ Store], then press OK.
Store your preferences.
Cancel
Press OK to fi nish [ Settings assistant].
The TV has learned your preferences.
Press Í /Æ to select [ Finish], then press OK.
Finish the Setup.
Note
•
If you are not receiving a signal from your cable service, contact the CATV provider.
•
If you press . during autoprogram, an installation will be canceled except the
language selection.
•
The initial autoprogram function can be executed for either [Antenna] or [Cable]
only once. When you change the connection (Antenna / Cable), set autoprogram again.
(Refer to page 34.)
Start
Picture B
Store
Exit
EN
11