Removing The Cover - IBM X3610 Installation Manual

v Remove the device from its package and install it directly into the server without
v Take additional care when handling devices during cold weather. Heating reduces

Removing the cover

Important: Before you install optional hardware, make sure that the server is
working correctly. Start the server, and make sure that the operating system starts.
If the server is not working correctly, see the Problem Determination and Service
Guide for diagnostic information.
To remove the cover, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. If you are planning to install or remove a microprocessor, memory module, PCI
3. Loosen the rack-release thumbscrews at the front of the server; then, pull the
4. Loosen the cover-release thumbscrews at the rear of the server.
5. Slide the cover back approximately 1.27 cm (0.5 inches); then, lift it off the
Attention:
the server. Operating the server for extended periods of time (more than 30
minutes) with the cover removed might damage server components.
12
IBM System x3610 Type 7942: Installation Guide
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on the server cover or on a
metal surface.
indoor humidity and increases static electricity.
on page 9.
adapter, fan, battery, or other non-hot-swap optional device, turn off the server
and all attached devices and disconnect all external cables and power cords
(see "Turning off the server" on page 29).
server out of the rack enclosure until both slide rails lock.
Note: You can reach the cables on the back of the server when the server is in
the locked position.
server and set the cover aside.
For proper cooling and airflow, replace the cover before you turn on
Cover release
thumb screws