Updating The Server Configuration - IBM X3610 Installation Manual

Hide thumbs Also See for X3610:
Table of Contents

Advertisement

Front view
Rear view
You must turn off the server before you connect or disconnect cables from the
server.
See the documentation that comes with any external devices for additional cabling
instructions. It might be easier for you to route cables before you connect the
devices to the server.
Cable identifiers are printed on the cables that come with the server and optional
devices. Use these identifiers to connect the cables to the correct connectors.

Updating the server configuration

Some optional devices have device drivers that you must install. See the
documentation that comes with each optional device for information about installing
device drivers.
The server comes with at least one microprocessor. If more than one
microprocessor is installed, the server can operate as a symmetric multiprocessing
(SMP) server. You might have to upgrade the operating system to support SMP. For
more information, see "Using the ServerGuide Setup and Installation CD" on page
31 and the operating-system documentation.
If you have installed or removed a hard disk drive, see "Using the RAID
configuration programs" on page 32 for information about reconfiguring the disk
arrays.
For information about configuring the integrated Gigabit Ethernet controllers, see
the User's Guide.
Power-cord
Mouse
Serial
connector
connector
connector
Keyboard
connector
3
0
4
1
5
2
Video
Ethernet
connector
connector 1
USB
System-management
connector 1
Ethernet connector
USB
connector 2
Chapter 2. Installing optional devices
USB 6
USB 5
connector
connector
Ethernet
connector 2
USB
connector 3
USB
connector 4
25

Advertisement

Table of Contents
loading

Table of Contents