IBM X3610 Installation Manual page 35

Hide thumbs Also See for X3610:

Table of Contents

Attention:

Do not touch the thermal grease on the bottom of the heat sink or

set down the heat sink after you remove the plastic cover. Touching the thermal

grease will contaminate it.

a. Remove the plastic protective cover from the bottom of the heat sink.

b. Align the heat sink above the microprocessor with the thermal grease side

down.

Heat-sink

Microprocessor

c. Press down firmly on the heat sink until it is seated securely.

Tighten the four screws that secure the heat sink to the system board.

8. Install the air duct.

If you have other optional devices to install or remove, do so now. Otherwise, go to

"Completing the installation" on page 24.

Thermal grease

Heat-sink

Chapter 2. Installing optional devices

Table of Contents