Panasonic AJ-SD965 Operating Instructions Manual page 75

Error messages
Error messages
ODescription
Display
OVTR operation and corrective action
E-64 If the supply reel motor speed is abnormally
high, the error number flashes on the display.
S REEL ROTA VTR: STOP
TOO FAST OSet the POWER switch to OFF and then to
ON again.
E-67 If the take-up reel motor speed is abnormally
high, the error number flashes on the display.
T REEL ROTA VTR: STOP
TOO FAST OSet the POWER switch to OFF and then to
ON again.
E-69 If excess torque being applied to the take-up
reel motor is detected, the error number flashes
T REEL on the display.
TORQUE ERR VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-70 If excess torque being applied to the supply reel
motor is detected or an abnormal current flowing
S REEL to the current detection resistor is detected, this
TORQUE ERR error number flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-71 If abnormal tension at the supply side is
detected in the capstan mode, the error number
CAP TENSION flashes on the display.
ERROR VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-72 If abnormal tension at the supply side is
detected in the reel mode, the error number
REEL TENSION flashes on the display.
ERROR VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-73 If the take-up reel motor has rotated in the
reverse direction, this error number flashes on
REEL DIR the display.
UNMATCH VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-74 If excess torque being applied to the cylinder
motor is detected, this error number flashes on
DRUM the display.
TORQUE VTR: STOP
ERROR OSet the POWER switch to OFF and then to
ON again.
E-78 If a problem has been encountered in
communication
SVDR COMM microcomputer and servo drive board, this error
ERROR number flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
(continued)
between the servo
Consult your dealer if the error message is still
displayed even after restarting the unit.
75