Display Panel - Panasonic AJ-SD965 Operating Instructions Manual

Parts and their functions

Display panel

TV system displays
The selected TV system is displayed here.
It is possible to switch between the 525 interlace
and 625 interlace systems by setting setup menu
item No. 070 (TV SYSTEM).
: This lights when the 525 interlaced TV system
525
has been selected.
: This lights when the 625 interlaced TV system
625
is selected.
WIDE lamp
This lamp lights when 16:9 wide-screen information
is being recorded on a tape.
Recording of wide-screen information can be
selected on setup menu No. 645 (WIDE SELECT).
This lights lamps during tape playback when wide-
screen information has been recorded on the tape.
REMOTE lamp
This lights when the REMOTE button
has been set to the remote mode.
INPUT SELECT display area
The characters corresponding to the selected input
signals light. With all input signals except for analog
audio signals, the fact that no signals have been
selected is indicated by a flashing display.
VIDEO
Y PB PR : Analog component video signals
(option)
CMPST : Analog
(option)
SDI : Serial digital video signals
SDTI/1394 : IEEE 1394 compressed digital signals
(option)
SG/SG 1/SG 2: Internal reference signals
AUDIO
ANALOG : Analog audio signals
AES/EBU : Digital audio signals
USER SET : Recording audio signal selection
SDI : Serial digital audio signals
SDTI/1394 : IEEE 1394 compressed digital signals
(option)
SG : Internal reference signals
16
(continued)
WIDE REMOTE
525 625
dB dB dB dB
0 0 0 0 CUE
dB
-4 -4 -4 -4
-8 -8 -8 -8 -8
-12 -12 -12 -12 -12
-16 -16 -16 -16 -16
-20 -20 -20 -20 -20
-25 -25 -25 -25 -25
-30 -30 -30 -30 -30
- - - - -
L R L R L R L R L R
(page 7)
composite video signals
SCH SERVO
VIDEO AUDIO
=
Y PB PR ANALOG
U
EDIT REC
CMPST AES/EBU
USER SET
DVCPRO
SDI SDI
50
SDTI/1394 SDTI/1394
DVCAM
SG 1 2 SG
CTL
TC
UB
lamp
U
This lamp lights when UMID information is present
on the input signal in E-E mode.
This lamp lights during tape playback when UMID
information has been recorded on the tape.
SCH lamp
This lamp lights when the SCH phase of the
external synchronized signal (REF VIDEO) is inside
the prescribed range.
At all other times, the lamp is off.
= lamp
This lamp lights when a cassette tape is inserted
into the VTR.
In the standby OFF mode, this lamp is flashing.
SERVO lamp
This lamp lights when the drum servo or capstan
servo locks.
Channel condition lamps
These lamps light to indicate the error rate status.
(green 5 white 5 red)
Green: This lights when the error rates for the video
and audio playback signals are both at
acceptable levels.
White : This lights when the error rate for the video
or audio playback level has increased.
The playback picture and sound remain
unaffected even while this lamp is lit.
Red : This lights when the error rate for the video
or audio playback level has increased to the
extent that correction or interpolation was
performed.
INH