Panasonic AJ-SD965 Operating Instructions Manual page 39

Setup menus
(continued)
SYSTEM menu
No./Item
18 System phase adjustment.
SYS H OFFSET 0000
0001
0002
0003
0004
0005
0006
<Note>
Factory settings will remain unchanged even if
an attempt is
19 This sets whether the system phase is to be
adjusted by the unit or from the external
SYS SC/H encoder remote controller.
0000 REMOTE :
The system phase is adjusted from the
external encoder remote controller.
0001 LOCAL :
The system phase is adjusted by the unit.
<Note>
The setting of this menu item has no effect when
the ENC CONTROL switch is at the LOCAL
setting.
The underlined items indicates the initial setting.
Video output signal adjustments
The video output signals are adjusted using combinations of the ENC CONTROL switch position and SYSTEM
menu item No.19 (SYS SC/H) setting.
These adjustments can be used for analog component, analog composite and SDI signal output.
A control matrix of the adjustments is shown below.
Setting
ENC CONTROL SYSTEM menu item
switch position 19: SYS SC/H
LOCAL
LOCAL
REMOTE
LOCAL
REMOTE
REMOTE
Description
–3 : –13.4 µsec
–2 : –8.96 µsec
–1 : –4.52 µsec
0 : 0 sec
1 : +4.52 µsec
2 : +8.96 µsec
3 : +13.4 µsec
SYSTEM menu item
11: SYS SC COAR.
12: SYS SC FINE
13: SYS H
Unit
Unit
External encoder remote
controller
No./Item
30 This adjusts the brightness of the LCD
monitor on the front panel.
BRIGHT
0000
:
0007
:
0014
<Note>
If setting operation is performed, the setting
value does not return to factory (default) setting.
31 This adjusts the contrast of the LCD monitor
on the front panel.
CONTRAST
0000
:
0007
:
0014
<Note>
If setting operation is performed, the setting
value does not return to factory (default) setting.
40 This selects whether the system file lock
mode is to be engaged or released.
MENU LOCK
0000 OFF : The lock is released (file data
0001
<Note>
Setup menu No. 00 (WFM SEL) can be changed
at any time regardless of the setting selected for
this menu item.
Item adjusted
Bottom of front panel
VIDEO LEVEL
CHROMA LEVEL
SET UP/BLC
HUE/CHROMA PH
Unit
External encoder remote controller
Description
–7
:
0
:
7
–7
:
0
:
7
can be changed).
ON : The lock is engaged (file data
cannot be changed).
39