Table of Contents
Advertisement
If there is no DHCP in your network, you can still auto provision your Yealink phone. Please
refer to your Yealink phone model User Guide for instruction about setting static IP address.
After you configure your Yealink phone to use a static IP address, continue with the following
steps.
Open a new browser window and enter your phone IP address in order to access the phone
web administration interface login screen. Example: http://192.168.1.22
Login to phone web administration interface with your username and password. Please note,
factory default login details are username: admin and password: admin.
Click on Upgrade tab.
Click Advanced tab.
URL
In the URL field enter the Hostname.
- Example for the Hostname: bicomsystems.com
Make sure you replace Hostname from this example with your PBXware Hostname.
Make sure DNS server is configured to automatically route registration request to a PBXware
which is actually under another domain name, example: newbicomsystems.com.
Check New Config
Select Power on + Repeatedly.
Click on the Confirm button.
You'll have to wait sometime prior for the device to save changes.
Click on the Auto Provision button to run auto provisioning process, then you'll be asked to
confirm action. To continue click on OK button.
Auto provisioning process will start during phone reboot process, phone will pickup
appropriate configuration file from PBXware. If everything is done as above described, you
should have successfully registered your phone to PBXware. Dial *123 to verify registration.
Configure BLF
This chapter describes how to configure BLF (Busy Lamp Field) for Yealink phones.
BLF (Busy Lamp Field) supported only with Yealink phone model SIP-T26P and SIP-T28P.
The following topics are covered:
- Extension Settings
- Phone Settings
NOTE:
Advertisement
Table of Contents
