Yealink SIP-W52P User Manual page 12

Hide thumbs Also See for SIP-W52P:
Table of Contents

Advertisement

In the URL field enter http:// or https:// followed by Hostname or IP Address, followed then
by /tftp/
- Example for Hostname using HTTP: http://voip.bicomsystems.com/tftp/ - Example for
Hostname using HTTPS: https://voip.bicomsystems.com/tftp/ - Example for IP Address using
HTTP: http://192.168.1.10/tftp/ - Example for IP Address USING HTTPS:
https://192.168.1.10/tftp/
Make sure you replace Hostname or IP Address from this example with your PBXware
Hostname or IP address.
Check New Config
Select Power on + Repeatedly.
Click on the Confirm button.
You'll have to wait sometime prior for the device to save changes.
Click on the Auto Provision button to run auto provisioning process, then you'll be asked to
confirm action. To continue click on OK button.
Auto provisioning process will start during phone reboot process, phone will pickup
appropriate configuration file from PBXware. If everything is done as above described, you
should have successfully registered your phone to PBXware. Dial *123 to verify registration.
DNS SRV
DNS SRV
This chapter describes how to use a DNS SRV record which specifies the location of the
PBXware.
NOTE:
Systems can provide service to set up this for you.
1. Check if the DNS SRV is enabled in your PBXware
Contact your PBXware administrator to find out if the DNS SRV is enabled in your PBXware,
or if you have access to the PBXware you can check this yourself.
Open a new browser window and enter the IP address in order to access the PBXware web
administration login screen. Example: http://192.168.1.10.
Login to PBXware with your e-mail address and password.
Navigate to Settings: Servers. Click on the server corresponding edit button.
In Auto Provisioning group, make sure Use DNS SRV when possible: is set to Yes. If it is
set to No or N/A, set to Yes and click on the Save button.
extensions configured for Auto Provisioning.
2. Login to phone web administration interface
Your DNS Server needs to be configured correctly for this to work. Bicom
NOTE:
You must re-save all your

Advertisement

Table of Contents
loading

Table of Contents