Samsung AR12JV5HATQ User & Installation Manual page 52

2) Smart Install mode in progress
• 88 Display : Progress will be displayed in 0~99 .
• LED Display : Indicator on the indoor unit display will blink in sequence and then all indicators will blink . (This will be
repeated . )
TYPE
Indoor unit indicator
❇ ❇ Display may be different depending on the model .
3. Smart Install Mode conclusion.
1) Smart Install mode will take approximately 7~13 minutes . (Actual time may be different depending on the model . )
2) When Installation is successful : Smart Install mode will end with ringing sound and the air conditioner will be in
standby status . (Error message will not be displayed on the indoor unit indicator and the remote controller and
buttons on the indoor unit will work normally . )
3) When installation is not successful : Smart Install mode will end and error message will be displayed on the indoor
unit display .
1 . Take necessary measures when error occurs .
- refer to the service manual for necessary measures for each error that occurs.
2 . Use the product after taking care of the error that occurs .
Error indicator
LED 1
Display
display and all
LED blinks
,
: Off / : Blinking /
❇ ❇
RAC BORACAY_EN_Eco-inverter IBIM_05124A-00.indd 51
88 Display
LED Display
LED 2 LED 3
: On
English-51
Error Measures to take by an installer
Error on indoor 1 . Check the connection of the connector
temperature sensor
Error on indoor 1 . Check the connection of the connector
heat exchanger
1 . Check the connection of the connector
Error on indoor fan
2 . Remove foreign substance (Check for the
motor
cause that restrains motor)
1 . Re-set options
EEPROM/Option
error
1 . Check if the service valve is completely
open .
2 . Check if there's any blockage in the
refrigerant pipe which connects indoor
Refrigerant flow
and outdoor unit .
blocking Error
3 . Check for refrigerant leak .
4 . Check if cross wired between indoor &
outdoor unit .
LED Display
LED1
LED2
LED3
2014-12-18 오후 3:06:56