Using The Auto Clean Function; Setting The Beep Sound - Samsung AR12JV5HATQ User & Installation Manual

Using the auto Clean function

Auto clean function will minimise the moisture inside of the indoor unit. Activate this function to help provide you with
clean air.
When the air conditioner is operating;
Indoor unit display

Setting the Beep sound

Beep sound from the indoor unit can be muted.
RAC BORACAY_EN_Eco-inverter IBIM_05124A-00.indd 25
1. Press the Settings button.
2. Press the button until (Clean) indicator starts to blink.
3. Press the SET button to set the auto clean function.
When the air conditioner is turned off,
f The Auto clean indicator (C1) on the indoor unit display appears and the Auto f
cleaning function runs .
When the air conditioner is turned on,
f The Auto clean indicator (C1) on the indoor unit display appears and the Auto f
cleaning function runs after stopping the air conditioner operation .
Auto cleaning time can vary, depending on the previously used mode .
Auto, Cool, Dry mode: approximately 30 minutes .
Fan mode: approximately 15 minutes .
If Auto clean function is turned on, "C1" displayed in the indoor unit .
After 3 second it will go to the previous setting temperature .
f Press the Settings button → press the
f
Cancel
to make the (Clean) indicator blink and press the SET button .
• When the air conditioner is turned on, the Auto clean function runs after
stopping the conditioner operation .
1. Press the Settings button.
2. Press the , or Settings button until (Beep) indicator starts to blink.
3. Press the SET button to mute the beep sound.
- 3 seconds after setting Beep sound function, (Beep) indicator on the remote
controller display will disappear and Beep sound function will stop .
English-25
or Settings button
,
2014-12-18 오후 3:06:45