Adjusting Hand And Day Indicator Alignment - Casio 5455 Operation Manual

8.
Press (C).
This changes to the month setting
operation.
12
11
1
10
9
4
8
5
7
6
Month
9.
Rotate the crown to change the month.
10.
Press (C).
The mode hand will move slightly,
indicating that the day setting operation is
enabled.
Day
Changing the date setting will cause the
●
mode hand to rotate repeatedly.
Changing Hand and the Day
l
Indicator Settings
11.
Rotate the crown to change the day.
12.
On a time signal at the top of a minute,
push the crown back in.
Adjusting Hand and
Day Indicator
Alignment
Strong magnetism or impact can cause the
time indicated by the hands and the day
indicator to go out of alignment. If this
happens, adjust hand and day indicator
alignment.
The watch performs alignment of the hour
●
hand, minute hand, second hand, and 24-
hour hand automatically.
Operation Guide 5455
Adjusting Hand and Day
Indicator Alignment
1.
Pull out the crown to the second click.
2.
Hold down (B) for about five seconds, until
2
the second hand moves to 12 o'clock.
＋
This will start auto alignment of the hour
3
−
hand, minute hand, second hand, and 24-
hour hand.
After auto alignment is complete, the
●
hands should be in the positions shown
below.
Second
hand
＋
3.
Press (C).
−
Confirm that the small hour hand and
small minute hand are stopped at 12
o'clock.
Small minute hand
4.
If the small hour hand and small minute
hand are not at 12 o'clock, rotate the
crown to align them correctly.
5.
Press (C).
Confirm that the mode hand is stopped at
12 o'clock, and check if the day is
indicated properly.
Minute hand Hour hand
Crown
24-hour hand
Small hour hand
Mode hand
Day (Operation start day)
6.
If the mode hand or the day indicator is not
in the proper position, rotate the crown to
move the mode hand to 12 o'clock and the
day to the center of the indicator window.
The movement range of the mode hand
●
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
After the mode hand and day indicator
●
are in the positions you want, advance
to step 9 of this procedure. If you are
unable to make the adjustments you
want, go to step 7.
7.
Press (C).
Confirm that the day indicator shows 1.
Day
Changing the date setting will cause the
●
mode hand to rotate repeatedly. In
some cases, the mode dial may
continue to rotate for about 30 minutes.
Changing Hand and the Day
l
Indicator Settings
8.
If 1 is not shown for the day, rotate the
crown until 1 is shown.
The mode hand moves in conjunction
●
with crown rotation. Move the mode
hand to 12 o'clock.
9.
Push the crown back in.
Note
Leaving the crown pulled out for
●
more than approximately 30 minutes
without performing any operation
will automatically cause the
adjustment operation to become
disabled. If this happens, push the
crown back in to its normal position
and then pull it out again to restart
the procedure from the beginning.
Pushing the crown in to its normal
position part way through the
alignment procedure will cause the
hands to return to their normal
position. Any alignment you
performed up to that point will be
applied.
12