© 2014 CASIO COMPUTER CO., LTD.
MA1410-EC
Basic Operations
The information below applies to all
modes.
Navigating Between Modes
Your watch has seven modes. Navigate
between modes as shown below.
Control Mode*
B
(Approximately
0.5 seconds)
Timekeeping Mode
World Time Mode
Setup Mode
Timer Mode
Stopwatch Mode
Use the (C) button to navigate between
modes. To enter the Control Mode, hold
down (B) for about 0.5 seconds.
* When the watch enters the Control
Mode, it will establish a connection
with the phone and the Bluetooth
indicator will appear on its display.
Bluetooth indicator
Operation Guide 5413
Using the Rotary Switch
Rotate the rotary switch to change
settings.
Rotating the rotary switch quickly three
●
times starts a fast forward or fast
reverse operation. To stop a fast
forward or fast reverse operation,
rotate the rotary switch in the opposite
direction or press any button.
Important!
Rotate the rotary switch without
●
pulling it out. Pulling with strong
force can cause malfunction or
damage.
Alarm Mode
To prevent error, the first
●
rotation performs no operation.
Keep rotating to perform the
desired operation. Error
prevention re-activates about
three minutes after the last
operation.
Shifting the Hands
Hour and minute hand shift moves the
hands for easy viewing of display info.
1. To shift the hour and minute hands,
hold down (L) as you press (C).
This will cause the hour and minute
●
hands to move to a position where
they do not block the digital
display.
The HANDS indicator flashes
●
while the hands are shifted.
Example:
Shifting the hands when it is 11:00
HANDS indicator
2. To return the hands to their normal
positions, holding down (L) as you
press (C) again.
Note
This function can be used in any
●
mode.
Watch button operations remain
●
the same when the hands are
shifted.
Changing to another mode
●
returns the hands to their normal
positions.
Shifted hands will return to their
●
normal positions if no button
operation is performed for one
hour.
In all modes, hands shift
●
automatically while settings are
being configured. They move
back to their normal positions
after settings are complete.
1