Table of Contents
Advertisement
Alarm N
An alarm will sound for 3 minutes at the set time. Set the date and time beforehand
(page 27).
1
{MENU} i {#}{7}{2}{0} i {OK}
2
{V}/{^}: Select the desired alarm mode. i {SELECT}
Turns alarm off. Go to step 5.
Off
The alarm sounds once at the set time. Enter the desired date.
Once
An alarm sounds daily at the set time.
Daily
3
Set the desired time. i {OK}
4
{V}/{^}: Select the desired ringer tone. i {SELECT}
L We recommend selecting a ringer tone different from the ringer tone set for
incoming calls.
5
{V}/{^}: "Save" i {SELECT} i {OFF}
Note:
L To stop the alarm, press any dial key or place the handset on the base unit or
charger.
L When the handset is in use, the alarm will not sound until the handset enters
standby mode.
L If you are on a call, beeps will sound and E will flash at the set time. The alarm will
not sound until you hang up.
L If you select "Once", the setting will change to "Off" after the alarm sounds.
L The ringer volume for the alarm follows the higher volume level of the 2 lines (page
52).
L When the ringer volume is set to off for both lines, the handset rings at the low level
for alarm.
Changing the handset name N
Each handset can be given a customized name ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between handsets. You can also select whether or not
the handset name is displayed in standby mode. The default setting is "Off". If you
select "On" without entering any handset name, "Handset 1" to "Handset 8" is
displayed.
1
{MENU} i {#}{1}{0}{4}
2
Enter the desired name (max. 10 characters; see the character table, page 39).
L If not required, go to step 3.
3
{OK}
4
{V}/{^}: Select the desired setting. i {SAVE} i {OFF}
For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Programming
55
Advertisement
Table of Contents
