Table of Contents
Advertisement
User Setup
This section covers programming of the system users. The SEC8 has a total of 9 users:
User 00 is the "Engineer" which cannot be selected or changed by the master user.
User 01 is the "Master" user which has a default code of 5678.
Users 02 to 08 can be programmed to any user type and default to "Not in Use".
When setting up a new user for the system the user must be assigned an access code, user
type, and optionally a time lock and name.
User Access Code
Each user must be assigned an access code in order to operate the system; access codes
may be 4, 5 or 6 digits in length.
To program a User Access Code, please proceed as follows:
Ensure that User Program Mode is selected.
User Menu:--
Option:----
User 02 Code:
ÿ
User 02 Code:
020202ÿ
Press
Press
Press
If the remote keypad generates an error tone after pressing the
step 3, then the access code cannot be used. Simply repeat the procedure from
step 2 but use an alternative access code at step 3.
P0031-LU-01.00
Enter option number:
81??
: Where ?? is user 01 to 08
*
Then press
e.g. Enter 8102* for User 02.
Enter new access code,
e.g, "020202".
*
to accept and return to step
R
to cancel and return to step
#
to accept and move to next option.
to edit.
Ì
.
Ë
.
Ur
81 02 =
81 02 =0 20
...
or
*
key at
#
27
Advertisement
Table of Contents
