Table of Contents
Advertisement
Test Bell & Outputs - 12*
This option allows the bell, strobe and any outputs that have the "User Test" attribute to be
switched on and off so that the devices connected to them may be tested. Normally the bell
and strobe outputs are connected to an external sounder unit.
To test the bell and strobe, please proceed as follows:
User Menu:--
12: Test Bell
Output Test 1-4:
Output Test 1-4:
Bell Active
Output Test 1-4:
Strobe Active
User Menu:--
01: Stay Arm 1
Only the outputs that have been programmed by your installer are activated during
the "User Test Outputs" option.
14
Enter your access code
12*
Enter
to select Bell Test
Use the following keys to toggle output:
1
BE
= Bell Output (
2
= Strobe Output
3
= User Test Outputs
4
= Alarm Sounder (
e.g. Enter 12 to select bell & strobe..
Repeat step 3 to toggle outputs on or off.
When finished press
99*
Enter
to exit the user menu.
????
.
)
ST
(
)
UT
(
)
AL
)
R
to exit the menu.
Ur
Ot
Ot
BE
St
Ur
P0031-LU-01.00
Advertisement
Table of Contents
