Normal Playback - Sanyo VWM-700 Instruction Manual

NORMAL PLAYBACK . . - - - - - - - - - - - -
24
PREPARATION
• Turn on the TV. \
• Be sure the TV is set to the VCR Output Channel (C H 3 or 4 ). \
• If a direct VIDEO/AUDIO connection is made betw een the
VCR and the TV, set the TV's source selector to VIDEO.
NORMAL PLAYBACK
1
Insert a prerecorded video cassette.
The <J""""O indicator will light and the VCR will power-up auto-
matically.
• Make sure that the TIMER indicator in the VCR indicator panel
is not lighted. If it is, press POWER once.
• If a tape without a safety tab is inserted the unit will start the
playback automatically.
2
Press PLAY once.
The PLAY appears in the VCR indicator panel and TV screen .
• It is not necessary to select the tape speed for playback. It will
be automatically selected by the VCR .
• In playback, the TV NCR selector switches to VCR mode auto-
matically.
3
Press STOP to stop playback.
The STOP appears in the VCR indicator panel and TV screen.
• If the tape reaches the end before STOP is pressed, the VCR
will automatically stop, rewind , eject, and it will turn itself off.
TRACKING CONTROL
AUTO TRACKING
The automatic tracking function adjusts the picture to remove
snow or streaks.
The AUTO TRACKING function works in the following cases:
• A tape is played back for the first time.
• Tape speed (SP, LP, SLP) changes .
• Streaks or snow appear because of scratches on the tape.
MANUAL TRACKING
If noise appears on the screen during playback, press either
CH/TRACK
(A/f)
on the remote control or CHANNEL
(A/T)
on
the front panel until the noise on the screen is reduced .
• In case of vertical jitter, adjust these controls very carefully.
• Tracking is automatically reset to normal when the tape is
ejected or the power cord is unplugged for more than 60
minutes.