Sanyo VWM-700 Instruction Manual page 27

NDRMAL RECORDING ,
Always use PAUSE for
best results when making
changes during recording.
For example: To change
channels during recording,
first press PAUSE to put
the unit in pause mode.
Then select the desired
channel on the VCR , and
press PAUSE again to
resume recording .
PREPARATION
• Turn on the power of both the VCR and TV.
• Be sure the TV is set to the VCR Output Channel (CH 3 or 4).
• If a direct VIDEO/AUDIO connection is made between the
VCR and the TV, set the TV's source selector to VIDEO.
1
Insert the video cassette that the safety tab is in place.
2
Select the desired channel by using CH/TRACK
(~) .
• If you are recording from another source via audio/video input
jacks (at the Rear or Front panel), select the LINE1 or LINE2
by pressing
INPUT.
3
Set the desired speed (SP or SLP) by pressing SP/SLP.
• This VCR is not designed to record in LP mode.
4
Set the MTS mode as desired (See page 18, 37).
5
Press REC once.
Recording will start. (The REC will appear)
• If a cassette with no safety tab is loaded, the cassette will be
ejected automatically.
6
Press STOP to stop recording .
• If the tape reaches the end before STOP is pressed, the VCR
will automatically stop, rewind, eject, and it will turn itself off.
To PAUSE the recording
During the RECORDING mode ...
1
Press PAUSE or PAUSE/STILL on the front panel to pause
the tape.
The RECP will show on the VCR indicator panel.
2
When you want to continue recording, press PAUSE or
PAUSE/STILL on the front panel again or press REC.
• After 5 minutes in pause mode, the tape will be stopped
automatically to protect the tape and the video heads.
To record one TV program while watching another
1
Press
TVNCR
to select the TV mode during recording.
The VCR indicator disappears.
2
Using the TV, select the channel to be viewed.
27