Mounting To The Transom - Suzuki DF70A Setup Manual

MOUNTING TO THE TRANSOM

Contained parts
Item Part name
A
Bolt (M12)
B
Washer (OD 35 mm)
C
Washer (OD 22 mm)
D
Nut (M12)
E
Cap
(1) Center the motor on the transom.
Make sure that anti-cavitation plate is located 0 – 25 mm (0
– 1 in.) below the boat bottom.
(2) Mark four position of motor mounting bolt on the transom
board.
(3) Drill the mounting holes using 12 mm drill bit.
NOTE:
• Drill the mounting holes vertically to transom board.
• Drill the upper holes at least 25 mm (1 in.) down from the tran-
som top surface.
(4) Install motor mounting bolts A with large diameter flat
washer B from inside of transom and through clamp
bracket.
(5) Install small diameter flat washers C and nuts D on clamp
bracket side.
(6) Tighten all mounting bolts/ nuts securely.
 Mounting bolt/nut: 55 N·m (5.5 kgf-m, 40 lb-ft)
(7) Install cap E to bolts A.
Part number Q'ty
09100-12091 4
09160-12044 4
09160-12110 4
09159-12014 4
41153-94500 4
360 (14.2)
327 (12.9)
Transom top surface
φ
5 – 13.5
13.5 (0.53)
251 (10) 38 (1.5)
9