Volume Measurement - Bosch GLM 50 C Operating/Safety Instructions Manual

tor for area measurement
pears in the status bar. Select area measurement by
pressing the measure button 2 [ ]. Activate the laser
by pressing the measure button 2 [ ]. The laser will
be switched on.
Aim and press the measure button 2
[ ] again to take the measurement
for length which will appear on the
4'02"
27⁄32
L
top line of the measured-value lines
0.0°
W 16'11"
1 6
d.
Aim and press the measure button 2
[ ] again to take the measurement
2
35.908ft
for width which will appear on the
middle line of the measured-value
lines d and the area will automatically be calculated
and display on the result line e.

Volume Measurement

For volume measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indicator
for volume measurement
appears in the status bar. Select volume measurement
by pressing the measure button 2 [ ]. Activate the
laser by pressing the measure button 2 [ ]. The laser
will be switched on.
Aim and press the measure button 2
[ ] again to take the measurement for
length which will appear on the top
4'02"
27⁄32
L
line of the measured-value lines d.
0.0° W
8'05"
1 6
Aim and press the measure button 2
12'08"
17⁄32
H
[ ] again to take the measurement for
3 width which will appear on the middle
456.45ft
line of the measured-value lines d.
Aim and press the measure button 2 [ ] again to take
the measurement for height which will appear on the
bottom line of the measured-value lines d and the vol-
ume will automatically be calculated and display on
the result line e.
and the word "Area" ap-
and the word "Volume"
-25-