Life Fitness Model 9500 Series HR and Telemetry Equipped Treadmills
How To... REMOVE AND REPLACE THE TRACKING SENSOR
SPRING ASSEMBLY
Tools Required: Standard Screwdriver
Step 1
The unit must be at minimum of 5.0% incline to have access to the TRACKING SENSOR SPRING ASSEMBLY.
Perform the following procedure to achieve this.
Enter the 'Service Mode' by:
1. Pressing the START key once.
2. Pressing the CLEAR key twice.
3. Pressing 919 on the numerical keypad. ( MANUAL, 919 if connected to Lifecenter ).
4. Pressing the START key.
5. Press the HILL key so it's L.E.D is lit.
WARNING: YOU ARE NOW IN THE SERVICE MODE PROGRAM. ONLY PERFORM THE STEPS MENTIONED
Step 2
Press the INCLINE UP key until 5.0% appears in the INCLINE (%) window.
Step 3
Turn the power OFF at the ON/OFF switch and then unplug the unit from the electrical outlet.
Step 4
With the help of another person, slowly tilt the unit on to it's left side.
Plug the unit back into the wall outlet. Turn the power ON at the ON/OFF switch, it will lower itself when powering
up. The unit is now ready for operation.
16
TO AVOID HARMING THE OTHER PROGRAMS.
Step 5
With a standard screwdriver, loosen and
remove the four SCREWS which secure
the ASSEMBLY to the FRAME of the
treadmill. Remove the worn TRACKING
SENSOR SPRING ASSEMBLY.
Step 6
Disconnect the 6 PIN CONNECTOR
leading to the worn TRACKING
SENSOR SPRING ASSEMBLY.
Step 7
Position a new TRACKING SENSOR
SPRING ASSEMBLY in place, reinsert
the four SCREWS and tighten with a
standard screwdriver. Reconnect the 6
PIN CONNECTOR to the new
ASSEMBLY.
Step 8
With the help of another person, slowly
tilt the machine back down to it's working
position.
Step 9