Alarm With Data; Acoustic Location Signal; Automatic Call After Alarm; Menu Operation - Mitel DT4X3 User Manual

Mitel DT4x3 Cordless Phones for MiVoice MX-ONE

7.4.1 ALARM WITH DATA

The data must manually be defined and stored by the user, see
page 62. It is recommended to add a shortcut for quick access to the "Edit alarm data"
menu, see

7.5 ACOUSTIC LOCATION SIGNAL

Depending on set parameters, the ramped up ALS is played after an alarm. The signal
is always ramped from the lowest volume to the highest. Press
Depending on the PDM settings, it is possible to make the user enter a password when
turning the ALS off. The password is the same as the phone lock password.
ALS is configurable for Man-down & No-movement alarm, and Push-button alarm. See
the handset's Configuration Manual for more information.

7.6 AUTOMATIC CALL AFTER ALARM

A handset can be setup to call a pre-defined number after an alarm has been sent. It is
also possible to dial the number without sending an alarm by pressing a push-button
that is not configured with alarm functionality. Depending on the settings, the call can
be established in the following modes;
• Loudspeaking mode
• Normal mode

8 MENU OPERATION

Figure 4. The Main Menu
7.When Bluetooth is enabled, the loudspeaker audio is lowered due to current limitations in the intrinsically safe handset.
1424-EN/LZT103 089 D1 2016-03-04
8.7 Short Cuts on page 60.
7
, or
Figure 4.
8
7
6
5
13:00
Messaging 1
2
3
4
Select Back
on
Edit Alarm Data
to turn the ALS off.
38