Custom Audio Electronics TK303 User Manual page 87

PAPER END
MANAGEMENT
RFID MODULE
BAUD RATE
PRINT DENSITY
Models with triple feeder
Management of the paper end sensors of triple feeder:
D
Print All = when the paper end sensor of a feed line of the triple feeder detects the
paper end, it is not possible to change the feed line until all tickets remain-
ing in that feed line are printed (so that the paper sensors of the printer will
have detected the end of paper)
Eject = when the paper end sensor of a feed line of the triple feeder detects the
paper end, the device automatically ejects the paper remaining on that feed
line and prints diagonal voiding lines on the remaining tickets
Retract = when the paper end sensor of a feed line of the triple feeder detects the
paper end, the device performs a paper retracting up to the parking position
Communication speed of the RFID module:
115200 38400 D
57600 19200
NOTE: if the RFID module is not recognized in the printer status ("RFID module = Not Present"), set this
parameter on the correct value.
Adjusting the printing density:
-50% -12% +25%
D
-37% 0 +37%
-25% +12% +50%
9600 2400
4800 1200
87