Electrolux ESL 5201LO User Manual page 8

8 www.electrolux.com
6.2 The water softener
The water softener removes minerals
from the water supply, which would have
a detrimental effect on the washing
results and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
Water hardness
German de‐
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt are
not effective enough to
soften hard water.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold the programme button until the
indicator
French de‐
grees (°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
starts to flash and
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. It is important to set the
right level of the water softener to assure
good washing results.
mmol/l Clarke de‐
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
<0.7 < 5
the indicator
fixed light.
2. Wait until the indicator
and the indicator
The indicator
flash. The intermittent flashing of the
indicator
level.
• E.g. 5 flashes + pause + 5 flashes
= level5.
3. Press programme button repeatedly
to change the setting. Each time you
press programme button the level
number increases. After level 10 you
will start again from level 1.
4. Press the on/off button to confirm the
setting.
Water softener
level
10
9
8
7
6
1)
5
4
3
2
2)
1
comes on with
goes off
starts to flash.
continues to
refers to the current set